Cut Profiles  

Executive Summary

Optimet’s ConoProbe MK10 with a 50 mm focal lens was used to inspect cut profiles. The tests were performed only to demonstrate measurement capability.  This report contains analysis results from the following samples: 
  • EGO‐BI
  • ABS‐PC

1. Optimet's Advantages over Other Technologies:

1. Unique collinear technology

2. Capability to measure sharp angles in minimum clearance  

3. High lateral resolution

4. High sampling rate with no need for averaging

2. Application Description

Scan two samples of cutting profiles using Optimet's ConoProbe MK10 with a 50 mm focal lens.

Test settings for both samples:  
  • Measurement rate: 9KHz
  • X‐step: 20 µm
  • Y‐step: 50 µm
  • Laser power level: 63

The scans were done in the Y‐direction so that the long spot side was along the scan direction.

3. Results and Observations

4. Data

Parameter Value
Reflective/Diffusive/Transparent/Translucent Diffusive
Working Range (mm) 6
Precision (µm) 5
Stand Off (mm) 44
Max. Data Rate (KHz) 9K
Lateral Resolution  -
Z Resolution  ‐ 
Application Category  ‐ 

Download Cutting Profile (pdf)